I also opted to get the extra slats installed so there is less gap. In hind sight, I probably should have held off on the optical tracer. All that ended up costing about $25K delivered. I ended up getting the optical tracer, tube cutter and engrave options installed on the system when I bought mine. I went with Arclight since I was able to get a turnkey product with a lot of extras. It looks like they have sold over 2000 systems so far. Third party videos of Torchmate are not too bad and I like them better.Ī few months ago, I purchased a 4x8 table from Arclight Dynamics with a Hypertherm 65. At work, there have been several times we have had a video playing, stop, do the action on the computer, then keep watching. It seems as if they are tailored for people who have a decent amount of experience already. The company made videos from Lincoln are not all that helpful. The Torchmate program does allow you import dxf files from any other program so that helps. Lincoln has a student version of the software you can download and perform nearly all actions except export to g-code. On the upside, there are plenty of videos to watch, Lincoln is a great company for service and support. It is more expensive than your budget allows though. Overall, it is a very well built machine and performs pretty well. It has a proprietary software installed that isn't bad, but is a bit different to learn. One of the offices where I work has a 4x4 Lincoln Torchmate. I am new to the plasma table game but here is my experience. I am sure will be by as well to add to this. This helps in warpage as well as aids in better cutting. If you do shop make sure you get a torch height control set up as this system measures "voltage" to control the space from the cutting tip to the work. If all the processes and steps are not taken, the machine will give you sour grapes. I will also tell you there is quite a big learning curve so do your homework on vendor support as it is critical. I did not factor in my air compressor with this either because I had a large one. I have a spread sheet where I kept track of every part/steel/material/nuts and bolts and I total in at 13K. I built my table using Precision Plasma gantry kit, CandCNC Command CNC controller set up and a Hypertherm 85 machine with water table. Not sure what 20K will get you but I will tell you this. I have seen many have good luck with FastCut CNC tables and have had good results. I can't give you any name per se, however I suggest you go over to Plasma Spider.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |